Leg Press Max Calculator (Leg Press 1RM Calculator)

Quick answer: enter the weight on the sled and your reps. Example: 200 kg × 8 reps ≈ 249 kg leg press 1RM. The result only applies to the machine you used, because sled weight and angle differ between brands.
More options

Estimated one rep max
–kg
–Training max (90%)
–× bodyweight
–Est. 5-rep max
% of 1RMLoadApprox. reps to failureTraining use
RepsPredicted max load% of 1RM

The weight you should be able to lift for each number of reps to failure, based on your estimated 1RM and the selected formula.

Loads for a given number of reps at each RPE (Rate of Perceived Exertion). RPE 10 = no reps left, RPE 8 = 2 reps left. Based on the widely used RPE/RIR percentage chart.

SetLoadRepsRest after

A conservative 1RM test built from your estimate. Stop at any attempt that slows down badly or loses technique – the last clean single is your 1RM. Always use a spotter or safety bars.

Each formula was fitted to a different group of lifters, so they disagree, especially above 10 reps. The spread shows how uncertain any single estimate is.

This leg press max calculator estimates your one rep max on the 45° sled, horizontal or vertical leg press from any set of 1–20 reps. The leg press is a great lift to estimate rather than test, because maxing out on it puts a lot of strain on your lower back and knees for little benefit. For free-weight lifts, see the squat max calculator or the main 1RM calculator.

Leg press 1RM from reps

Reps to failureAt 150 kgAt 200 kgAt 250 kgAt 405 lb
5173.2230.9288.6467
6177.8237.0296.3480
8187.0249.3311.7505
10196.4261.9327.3530
12206.0274.7343.4556
Seven-formula average. Leg press sets of 5–10 work well.

Why leg press numbers don’t travel between gyms

  • Sled weight: the empty carriage can weigh anywhere from very little to over 50 kg, and some gyms count it while others don’t. Decide whether you include it and stay consistent.
  • Angle: on a 45° sled you only push against part of the load (about 70%, since sin 45° ≈ 0.71, before friction), so plate totals look far bigger than squat numbers.
  • Range of motion: seat position and depth change the result hugely. Count only reps where your knees reach about 90° or deeper, without your lower back curling off the pad.

Because of this, there’s no reliable way to convert a leg press max into a squat max. Use the number to track progress on your machine.

Using your leg press max

The leg press shines as a muscle-building exercise, so most people train it in the 8–15 rep range, at roughly 65–80% of their estimated max. Take sets close to failure. Machines are a safe place to push hard, because you can rack the sled on the safety stops. Check the % of 1RM tab above for exact loads, or the printable one rep max chart.

Leg press FAQs

Should I include the sled weight?

Either is fine. Just be consistent and note it. If you’re comparing with a friend on a different machine, the comparison won’t mean much anyway.

Is it safe to test a 1RM on the leg press?

It’s possible, but heavy singles with deep knee bend can round your lower back off the pad. Estimating from a set of 5–10 controlled reps is safer and accurate enough for training.

Estimates are for training purposes only and aren’t medical advice.