Power Clean Max Calculator (Power Clean 1RM)

Quick answer: enter a power clean set of 1–3 reps. Example: 80 kg × 3 reps ≈ 87.5 kg power clean 1RM. Rep formulas are less reliable for technique-limited lifts, so don’t use sets above 3–5.
More options

Estimated one rep max
–kg
–Training max (90%)
–× bodyweight
–Est. 5-rep max
% of 1RMLoadApprox. reps to failureTraining use
RepsPredicted max load% of 1RM

The weight you should be able to lift for each number of reps to failure, based on your estimated 1RM and the selected formula.

Loads for a given number of reps at each RPE (Rate of Perceived Exertion). RPE 10 = no reps left, RPE 8 = 2 reps left. Based on the widely used RPE/RIR percentage chart.

SetLoadRepsRest after

A conservative 1RM test built from your estimate. Stop at any attempt that slows down badly or loses technique – the last clean single is your 1RM. Always use a spotter or safety bars.

Each formula was fitted to a different group of lifters, so they disagree, especially above 10 reps. The spread shows how uncertain any single estimate is.

The power clean is fast, technical and limited by bar speed, not just strength. That makes it the hardest lift to estimate from reps, because once you’re tired the bar simply doesn’t get high enough to catch, even though your muscles could still produce force. This power clean max calculator is pre-set for low reps, and the advice below explains how coaches actually use clean percentages. For slow strength lifts, the main 1RM calculator is more precise.

How to estimate your power clean max

  • Use singles, doubles or triples. Enter the heaviest set where every rep was caught cleanly above parallel.
  • Don’t count muscled or pressed-out reps. If you had to curl it or press it out, it doesn’t count.
  • Treat touch-and-go reps with care. Reset between reps if you can.
SetAt 60 kgAt 80 kgAt 100 kg
1 rep6080100
2 reps63.684.8106.0
3 reps65.587.4109.2
Estimated power clean 1RM, seven-formula average. Treat it as a guide only.

Power clean percentages in training

Olympic lifts are trained mostly with low reps at moderate-to-high percentages, so every rep stays fast. A common pattern:

FocusSets × reps% of 1RM
Technique and speed5–6 × 2–360–70%
Power5 × 275–85%
Heavy singles3–5 × 185–95%

These match the power guidance in our 1RM training zones: 80–90% for single-effort power, 75–85% for repeated efforts. Use the Plate loader tab with a 15 kg bar if you lift with a women’s Olympic bar.

How your clean relates to other lifts

Many coaches use the power clean as a rough guide to how well an athlete converts strength into speed. A power clean far below your deadlift max or front squat usually means technique or speed is the limiter, not strength. In that case, more clean practice at 60–75% will usually move your max more than extra squatting.

Power clean FAQs

Can I estimate my clean from a 5-rep set?

You can, but expect a lower-quality estimate. Technique breaks down before strength runs out, so 5-rep cleans tend to under-estimate your single. Doubles and triples are much better.

Does this work for the hang clean or squat clean?

Yes. Estimate each variation separately. Squat cleans usually allow more weight than power cleans, and hang cleans usually less.

Estimates are for training purposes only. Learn Olympic lifts with a qualified coach.