Strength Calculator: How Strong Am I? (DOTS Score)

How strong am I? Enter your bodyweight and your best squat, bench and deadlift sets (any reps from 1 to 12). The calculator estimates each 1RM, adds up your total, and gives your DOTS score, the bodyweight-adjusted rating used in powerlifting, plus how each lift compares with your bodyweight.

Enter your best set for each lift. Use reps = 1 if you know your true max.

Squat
Bench press
Deadlift
DOTS score
–
–Estimated total (1RMs)
–Total × bodyweight

DOTS compares lifters of different bodyweights using the formula adopted in powerlifting from 2019. Higher = stronger for your size.

LiftEst. 1RM× BWNext milestone

Raw numbers don’t tell the whole story: a 200 kg deadlift is very different for a 60 kg lifter and a 120 kg lifter. This strength calculator puts your lifts in context. It uses the same seven-formula method as our 1RM calculator to turn your sets into one rep maxes, then rates them by bodyweight with the DOTS formula and simple bodyweight ratios.

What is a DOTS score?

DOTS (Dynamic Objective Team Scoring) is a formula that adjusts a powerlifting total for bodyweight, so lifters of every size can be compared on one scale. It replaced the older Wilks formula in many federations around 2019–2020. It works by dividing your total by a curve fitted to bodyweight, with separate curves for men and women:

DOTS = total (kg) × 500 ÷ (a·BW⁴ + b·BW³ + c·BW² + d·BW + e)

You don’t need to do the maths. The calculator handles the coefficients and works in kg or lb. The key point is that a higher DOTS means stronger for your size. Scores are most meaningful when you compare them with your own past scores, or with lifters in the same federation.

Bodyweight ratios: a simpler yardstick

For individual lifts, a lift-to-bodyweight ratio is easy to understand and to set goals with. The calculator shows your ratio for each lift and the next common milestone. These widely used coaching milestones are rules of thumb, not official standards:

LiftEarly milestoneSolid intermediateAdvanced
Squat1× bodyweight1.5×2×+
Bench press0.75×1–1.25×1.5×+
Deadlift1–1.5×2×2.5×+
Typical for adult men. Women’s ratios are commonly about 20–40% lower, especially for the bench press. Age, height and training history all matter.

Are your lifts balanced?

The calculator also compares your lifts with each other. Typical ranges:

  • Bench ≈ 60–75% of squat. Much lower usually means the upper body needs attention. Much higher often means the squat has room to grow.
  • Squat ≈ 80–90% of deadlift. A big gap often points to weaker quads or a technique issue in the squat.
  • Overhead press ≈ 60–70% of bench. Check it with the OHP calculator.

These aren’t rules. Body proportions change them a lot. Long arms favour the deadlift, short arms and a big chest favour the bench. But a ratio far outside the usual range is worth a look.

Getting the most accurate result

  • Use recent, hard sets of 1–6 reps for each lift. For individual estimates, use the squat, bench press and deadlift calculators.
  • Use your morning bodyweight, measured on the same scale each time.
  • Count competition-standard reps only: squat to depth, paused or touch bench, full deadlift lockout.
  • Remember that estimates from reps tend to under-state the deadlift slightly (LeSuer et al., 1997).

How to get stronger from here

Pick your weakest ratio and give it priority for a training block. Train it 2–3 times a week, mostly at 70–85% of your max, adding weight gradually. Use the 1RM percentage chart or the RPE calculator to set loads, and re-check your numbers here every 6–8 weeks.

Strength calculator FAQs

How strong am I compared with other people?

Your DOTS score lets you compare yourself with lifters of any bodyweight. Bodyweight ratios give a quick, lift-by-lift answer. Both say more than raw kilos.

Is DOTS better than Wilks?

DOTS was introduced to fix biases found in the original Wilks formula across very light and very heavy lifters, and many federations now use it. Both give similar rankings for most lifters in the middle bodyweight classes.

What is a good strength-to-bodyweight ratio?

Commonly cited intermediate goals for men are a 1.5× squat, 1–1.25× bench and 2× deadlift. For women, roughly 20–40% lower. These are rules of thumb, not official standards.

Ratios and milestones are general guides, not official standards. For training guidance only.